Deluxe Universal 11" x 19" Carbon Fiber Dual Temp Heated Seat Heater Kit
If you have always wanted to add factory like heated seats to your Vehicle or Boat, then this Heated Seat kit is the ideal kit and the ideal solution whether you own a car, SUV, Truck, Boat or Plane.
Carbon Fiber technology is the best seat heating pad material in the marketplace.
The first reason is that the Carbon Fiber thread is pliable and a good conductor of electricity which can be designed to incorporate a variety of shapes which are interconnected and form a grid which can be sewn over. Carbon Fiber will not corrode, become weak or break like copper heating elements.
Second, this Universal Carbon Fiber Seat Heater kit allows the installer to trim the length of the carbon fiber pads or to cut holes in the center of the pads to accommodate any seat design or seat sensor and still provide heat. Pads are cut with regular scissors or razor blade to create any pattern to fit any seat.
Third, the honeycomb heating fibers ensure long life and dependability. With conventional, serial seat heaters, any abuse that breaks the heating wire shuts off the entire heater; the same abuse would only render a small portion of our heater inoperative so the driver will still be cozy and warm!
Fourth, Ultra-thin carbon fibers mean no bulky and uncomfortable wires. Other than the soothing warmth there's nothing to make the driver or passenger think their seats are out of the ordinary!
This kit will install in any seat with a 12 volt electrical system. This kit is for a single seat's back & bottom. This 2 pad kit is designed to install between your seat upholstery (Leather, Vinyl or Cloth) and the padding underneath. Installation may require removal and re-installation of seat and seat covers, as well as basic knowledge of the vehicle's wiring.
These pads have been designed to these dimensions to enable a universal fit in older as well as newer style seats. Pads are approximately 1/32" thick. Either pad can be installed in back or bottom.
Current Draw: 4 Amps on Low Heat Setting and 5 Amps on High Setting per Seat.
2 Wire Installation (Red to +12Volts & Black to Ground) Everything plugs into each other.
Switch is pre-soldered. 3' Switch Harness Extension available for $5.00
|13/16" (21mm) Seat Heater Heated Seats Kit Waterproof Switch Cover|
This is a clear plastic cover for 13/16" (21mm) round switch. Cover snaps on and offers protection from the elements. It only covers the top of the switch.
|3 Foot Seat Heater Switch Extension3 Foot Seat Heater Switch Extension|